Lenovo ThinkServer RD540 - Manual (Page 107)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 89
4. Have the QLogic Adapter directly connected, or through a switch, to the storage device. Be sure the
storage device and the switch (if used) are both powered up and completely initialized before
proceeding. Be sure all devices are visible to all other devices on the switch. If VLANs are enabled, the
QLogic Adapter and storage device must be on the same VLAN. Refer to the switch vendor
documentation on switch configuration.
5. Ensure that the storage device allows access to the QLogic Adapter. Refer to the vendor-specific
documentation to determine how to enable this access.
6. If you have not already done so, download and install the BIOS on the QLogic Adapter.
The latest BIOS is available on the QLogic Web site, http:\\driverdownloads.qlogic.com.
7. Start the system; press Ctrl+Q when the BIOS screen for the QLogic Adapter opens.
The Fast!UTIL Options menu opens.
8. Select Configuration Settings.
9. Select Host Adapter Settings.
10. Enable the Host Adapter BIOS.
11. Press ESC to exit the Host Adapter Settings window.
12. Select iSCSI Boot Settings.
13. Enable iSCSI Boot.
DHCP Boot Setup for iSCSI Boot (IPv4)
DHCP boot provides a method for the iSCSI initiator to acquire target parameters from a DHCP server. To
configure the DHCP server to support iSCSI boot, first ensure that your DHCP server is set up.
iSCSI Boot Setup Using QCC CLI
For information about iSCSI boot setup using the QCC CLI, refer to the QConvergeConsole CLI User’s
Guide for information on the QLogic Web site http://driverdownloads.qlogic.com.
Configuring iSCSI Boot Using the QCC CLI
Configuring iSCSI Boot Using Interactive QCC CLI For information about configuring iSCSI boot
using the interactive QCC CLI, refer to the QConvergeConsole CLI User’s Guide for information on the
QLogic Web site http://driverdownloads.qlogic.com.
Configuring iSCSI Boot Using Non-interactive QCC CLI For information about configuring iSCSI boot
using non-interactive QCC CLI, refer to the QConvergeConsole CLI User's Guide, “iSCSI Noninteractive
Commands” on the QLogic Web site http://driverdownloads.qlogic.com.
Configuring iSCSI DHCP Boot Options Using QCC CLI
Configuring iSCSI DHCP Boot Options Using Interactive QCC CLI For information about configuring
iSCSI DHCP boot options using interactive QCC CLI, refer to the QConvergeConsole CLI User's Guide on
the QLogic Web site http://driverdownloads.qlogic.com.
Configuring iSCSI DHCP Boot Options Using Non-interactive QCC CLI For information about
configuring iSCSI DHCP boot options using non-interactive QCC CLI, refer to the QConvergeConsole CLI
User's Guide, “iSCSI Noninteractive Commands” section on the QLogic Web site
http://driverdownloads.qlogic.com.
iSCSI Boot Setup Using QCC GUI
For information about iSCSI boot setup using QCC GUI, refer to the Configuring Boot Settings section in
the QConvergeConsole Help System.