Kodak ESP 7 - Manual (Page 34)

Setting Up Your Printer
26 www.kodak.com/go/aiosupport
8. After completing your entry, select the DONE key, and then press OK .
The LED will be continuously lit when you are connected to a wireless network. This
does not guarantee you are connected. You must verify that you are connected. See
Verifying network configuration, page 27 .
Connecting to an unlisted network
1. Wi-Fi Setup Wizard is the first option; press OK to select it.
2. If you network does not appear in the list and is configured to not broadcast its
SSID, select Unlisted Network and press OK .
3. Follow the prompts to enter the network name using the keyboard visible on the
LCD screen. Press , , or to select a key. Enter the alphanumeric
string accurately, using the same upper and lower case letters as your SSID.
After completing your entry, select the
DONE key, and then press OK .
4. Select WEP or WPA/WPA2 as required for your network's security setup, and
then press OK .
5. Enter the security information required using the LCD screen keyboard.
• Press , , or to select a key. Select < BKSP > to erase any incorrect
characters. Then select DONE and press OK .
6. After the confirmation message appears on the LCD screen, press OK to display
the Network Settings menu.
Scanning for wireless networks
If you don’t see your network in a list or want to change your network:
1. Select Rescan for wireless networks .
2. Press OK .
LED Status Description
Fully lit When lit, signals that a wireless (Wi-Fi) network connection has
authenticated to the router, but your connection may not be active.
You can verify the connection through the Network Settings menu.
Blinking Blinks when
• searching for an available Wi-Fi network within range
• existing signal is too weak to transmit
The LED has a repetitive cycle of blinking, then resting for 15 seconds,
followed by blinking again. The Wi-Fi radio will continue to attempt
connection to the network until a connection is established.