Kodak ESP 7 - Manual (Page 30)

Setting Up Your Printer
22 www.kodak.com/go/aiosupport
Ethernet setup
1. Plug one end of the Ethernet cable into the Ethernet port located on the back of
the printer and the other end into an available port on your Ethernet router or
hub.
2. Turn on the printer, if necessary.
3. From the control panel, press Menu .
4. Press until Network Settings is selected.
5. Press OK .
6. Verify the connection.
Configuring a wireless network connection
You can connect your printer to a 802.11 wireless (Wi-Fi) network from the printer
control panel.
The wireless (Wi-Fi) network status light on your printer has the following
conditions:
LED Status Description
Fully lit When lit, signals that a wireless (Wi-Fi) network connection has
authenticated to the router, but your connection may not be active.
You can verify the connection through the Network Settings menu.
Blinking Blinks when
• searching for an available Wi-Fi network within range
• existing signal is too weak to transmit
The LED has a repetitive cycle of blinking, then resting for 15 seconds,
followed by blinking again. The Wi-Fi radio will continue to attempt
connection to the network until a connection is established.