Aiwa CX-NHMT75 - Manual (Page 14)

14
ENGLISH
MUSIC SENSOR
If there is a 4-second or longer blank between each track, a search
for the beginning of the current or next track during playback can
be done easily.
Press
f or g during playback referring to the playback side
indicator ( x or c) on the display.
For example, when g is pressed while c is displayed, playback
of the next track starts.
Music sensor function may not be able to detect tracks under the
following conditions:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press TAPE/DECK1/2 to select the deck to be
played back first.
3 Press REV MODE to select [.
4 Press d to start playback.
Playback continues until s is pressed.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to cover
the Type II tape detection slot.)
• 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
• Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
Type II tape
detection
slot Tab for side A
Side A