Aiwa CX-NHMT75 - Manual (Page 11)

En
ENGLISH
11
STORING THE NEW EQUALIZATION
CURVES
Up to 5 customized equalization curves can be stored as the
manual modes M1 - M5.
1 Go through steps 1-4 of “Setting a New
Equalization Curve Manually”.
The created curve is displayed for 8 seconds.
2 Within 8 seconds, press ENTER.
“M 1” flashes on the display for 8 seconds.
• If this step is not completed within 8 seconds, press GEQ
first to display “GEQ ON”. Then within 4 seconds press
ENTER repeatedly until “M1” flashes.
3 Within 8 seconds, turn MULTI JOG to select one
of the manual modes M1 - M5 to store the curve.
4 Within 8 seconds, press ENTER.
The new equalization curve is stored.
To select the stored equalization curve
Press GEQ, and turn MULTI JOG to select one of the manual
modes M1 - M5 within 4 seconds.
DSP SURROUND
The DSP (Digital Signal Processor) SURROUND adjusts the
delay time, the input mode and the feedback level to give a
resonant surround sound, allowing you to enjoy the real sound
presence of different environments.
This unit has been programmed with 5 different SURROUND
modes.
SELECTING A PROGRAMMED DSP
SURROUND MODE
Five modes of DSP SURROUND offer the sound presence you’d
experience in disco (DISCO), at a live concert (LIVE), stadium
(STADIUM), in a concert hall (HALL) or movie theater (MOVIE).
(Shown in parentheses are indications appearing in the display.)
Press SURROUND, and turn MULTI JOG or press
f
f f f f or g g g g g repeatedly to select the desired
Programmed mode within 4 seconds.
“DSP SURROUND” appears and the DSP SURROUND mode is
displayed cyclically as follows.
DISCO LIVE MOVIE HALL STADIUM
Equalization curves are selected automatically to match the DSP
SURROUND modes and can also be selected or turned off to
suit your preference.
To display the current DSP SURROUND mode
Press SURROUND. The current mode is displayed for 4 seconds.
To cancel the selected mode
Press SURROUND twice. “DSP OFF” appears and “DSP
SURROUND” disappears.
When the music source is monaural
Select “LIVE”, “MOVIE” or “STADIUM” to obtain a simulated stereo
effect.
When “DISCO” or “HALL” is selected, no sound will be heard
from the surround speakers.
SOUND
To adjust the volume of the surround speakers
Press MANUAL SELECT twice or three times on the remote
control.
“S-L” or “S-R” is displayed for 4 seconds. Press
f DOWN or
g UP on the remote control within these 4 seconds.
• The DOLBY PRO LOGIC (page 21) and the DOLBY DIGITAL
SURROUND (page 29) surround speakers level is also
changed.
The DSP SURROUND mode is canceled when:
- the ECHO level is changed.
- the DOLBY PRO LOGIC is turned on.
- the headphones are plugged in.
- the 5.1 CH (page 29) is selected.