Aiwa CX-NHMT75 - Manual (Page 10)

10
ENGLISH
SETTING A NEW EQUALIZATION CURVE
MANUALLY
The equalization curve can be customized to suit your preference.
1 Press GEQ, followed by ENTER within 4 seconds.
Your customized setting will be based on the currently selected
curve. To select a different curve to work on, turn MULTI JOG
before pressing ENTER.
The display will be switched to read “GEQ LOW.”
2 Within 8 seconds, turn MULTI JOG to adjust the
level of the lowest frequency.
3 Press ENTER to let “GEQ HIGH” show.
The highest level frequency indicator flashes for 8 seconds.
4 Within 8 seconds, turn MULTI JOG to adjust the
level of the highest frequency.
The frequency level indicators of between the lowest and the
highest are adjusted accordingly.
If you do not store your customized equalization curve, it will be
lost when you switch to a different curve or press GEQ. To store
the new curve, see below.
Using the headphones
Connect headphones to the PHONES jack with a standard stereo
plug (ø6.3 mm,
1 / 4 inch).
No sound is output from the speakers while the headphones are
plugged in.
• When the headphones are plugged in, the DSP SURROUND
system, the DOLBY PRO LOGIC and the 5.1 CH (page 29) do
not function.
Sound adjustment during recording
The VOLUME control has no effect on recording, while the BBE
affects recording.
GRAPHIC EQUALIZER
SELECTING THE PROGRAMMED
EQUALIZATION CURVE
This unit provides the following 5 different programmed
equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
LATIN: Accented higher frequencies for latin music.
CLASSIC: Enriched sound with heavy bass and fine treble.
JAZZ: Accented lower frequencies for jazz-type music
Press GEQ, and turn MULTI JOG to select one of the
programmed equalization curves within 4 seconds.
“GRAPHIC EQUALIZER” appears and the GEQ mode is
displayed cyclically as follows.
ROCK POP JAZZ
M5
CLASSIC LATIN
Programmed mode
Manual mode
M1 M2 M3 M4
To display the current GEQ mode
Press GEQ. The current mode is displayed for 4 seconds.
To cancel the selected mode
Press GEQ twice.
“GEQ OFF” appears and “GRAPHIC EQUALIZER” disappears.
To select with the remote control
Press GEQ, and within 4 seconds press f f f f for g g g g g repeatedly.
The GEQ mode is displayed cyclically as above.