Kramer Electronics TP-107AV - Manual (Page 20)

Configuring a TP-107V / TP-107AV System
17
Figure 13: Connecting the TP-107AV
5.2 Configuring the TP-107AV / TP-122 Kit with the RC-108
1
To configure a presentation system as illustrated in the example in Figure 14,
do the following:
1. Connect the computer graphics source on each TP-107AV 2 machine in
the chain (see section 5.1).
2. Interconnect the TP-107AV machines via the C-STP+KNET-6 cables.
3. Connect the RC-108 Presentation Controller to the chain via the RS-485
port.
4. Connect the last TP-107AV unit to a receiver (for example, the Kramer
TP-122 3 ), which is connected to an acceptor (for example, a projector and
an AV receiver with speakers).
5. Set the RS-485 TERM switch on the first unit to ON.
6. Set a machine number for each machine via the dipswitches
(see section 5.6).
1 From this section on, the RC-108 applies also to the RC-116, unless stated otherwise
2 You may connect both types in the same chain
3 Refer to the separate user manual, which can be downloaded at http://www.kramerelectronics.com