Kramer Electronics TP-107AV - Manual (Page 2)

Contents
i
Contents
1 Introduction 1
1.1 The C-STP+KNET-6 Cable 2
2 Getting Started 2
2.1 Quick Start 2
3 Overview 4
3.1 About the TP-107V / TP-120 BoardView
TM
Kits 4
3.2 About the TP-107AV / TP-122 Kits 6
3.3 Controlling via the RC-108 and RC-116 Presentation Controllers 7
3.4 Recommendations for Achieving the Best Performance 7
4 Your Line Transmitters and Presentation Controllers 8
4.1 Your TP-107V and TP-107AV Line Transmitters 8
4.2 Your TP-120/TP-122 Line Receiver 10
4.2.1 Your TP-120 XGA Line Receiver 10
4.2.2 Your TP-122 XGA / Audio Line Receiver 12
4.3 Your RC-108 / RC-116 Presentation Controller 13
5 Configuring a TP-107V / TP-107AV System 16
5.1 Connecting the TP-107V / TP-107AV 16
5.2 Configuring the TP-107AV / TP-122 Kit with the RC-108 17
5.2.1 Connecting the RC-108 to the TP-107AV / TP-122 Kit 18
5.3 Wiring the CAT 5 LINE IN / LINE OUT RJ-45 Connectors 19
5.4 Connecting the RS-232 Port 19
5.5 Connecting via the RS-485 20
5.6 Setting the Dipswitches of the TP-107AV 20
6 Flash Memory Upgrade 21
6.1 Downloading from the Internet 21
6.2 Connecting the PC to the RS-232 Port 22
6.3 Upgrading Firmware 22
7 Technical Specifications 27
Figures
Figure 1: TP-107V / TP-120 Kit 5
Figure 2: TP-107V XGA Line Transmitter 8
Figure 3: TP-107AV XGA / Audio Line Transmitter 8
Figure 4: TP-107V / TP-107AV Underside Panel reference 9
Figure 5: TP-120 XGA Line Receiver 10
Figure 6: TP-120 XGA Line Receiver (Underside) 11
Figure 7: TP-122 XGA / Audio Line Receiver 12
Figure 8: TP-122 XGA / Audio Line Receiver (Underside) 13
Figure 9: RC-108 Presentation Controller 13