Kramer Electronics VS-808YC User Manual

Page 22

Operating the VS-808YC

8.4 Confirming Settings

Choose to work in the AT ONCE or the CONFIRM mode, as section 8.4.1

describes. When the

VS-808YC operates in the AT ONCE mode, pressing an

OUT-IN combination implements the switch immediately. In the CONFIRM

mode, the TAKE button must be pressed to authorize the switch.
In the AT ONCE mode, you save time as execution is immediate and actions

require no user confirmation. However, no protection is offered against

changing an action in error.
In the CONFIRM mode:

You can key-in several actions and then confirm them by pressing the

“ TAKE” button, to simultaneously activate the multiple switches

Every action requires user confirmation, protecting against erroneous

switching

Execution is delayed

until the user confirms the action

8.4.1

Toggling between the AT ONCE and CONFIRM Modes

To toggle between the AT ONCE and CONFIRM modes, do the following:
1. Press the unlit TAKE button to toggle from the AT ONCE mode (in

which the TAKE button is not illuminated) to the CONFIRM mode (in

which the TAKE button illuminates).

Actions now require user confirmation and the TAKE button illuminates.

2. Press the illuminated TAKE button to toggle from the CONFIRM mode

back to the AT ONCE mode.

Actions no longer require user confirmation and the TAKE button no

longer illuminates.

8.4.2

Confirming a Switching Action

To confirm a switching action (in CONFIRM mode), do the following:
1. Press an OUT-IN combination.

The corresponding digits in the 7-segment Display blink. The TAKE

button also blinks.

2. Press the blinking TAKE button to confirm the action.

The corresponding digits in the 7-segment Display no longer blink. The

TAKE button illuminates.

1 Failure to press the TAKE button within one minute (the Timeout) will abort the action