Kramer Electronics VS-808YC - Manual (Page 12)

Connecting the VS-808YC
9
6 Connecting the VS-808YC
This section describes how to connect the VS-808YC. In particular, how to:
Connect the VS-808YC rear panel (see section 6.1)
Control via RS-232, for example, using a PC (see section 6.2)
Control via RS-485 (see section 6.3)
Connect the audio inputs/outputs (see section 6.4)
Set the DIP-switches (see section 6.5)
6.1 Connecting the VS-808YC Rear Panel
To connect the VS-808YC, as the example in Figure 3 illustrates, do the
following 1 :
1. Connect up to 8 s-Video sources 2 to the 8 VIDEO (Y/C) 4-pin input
connectors, and connect 3 up to 8 balanced stereo audio sources 2 to the 8
“AUDIO INPUTS” terminal block connectors.
2. Connect 4 the 8 VIDEO (Y/C) 4-pin output connectors to up to 8 s-Video
acceptors (for example, s-Video recorders) and connect up to 8 “AUDIO
OUTPUTS” terminal block connectors to the balanced stereo audio
acceptors (for example, power amplifiers and speakers).
3. Set the DIP-switches (see section 6.5).
4. If required, Connect a PC to the RS-232 port (see section 6.2).
5. Connect the power cord
5 .
1 Switch OFF the power on each device before connecting it to your VS-808YC. After connecting your VS-808YC, switch on
its power and then switch on the power on each device. DO NOT push in the rear panel Flash Program “Program” button
(item 9 in Table 2) and DO NOT push in the underside Flash Program “Reset” button. These are only used for upgrade to the
latest Kramer firmware (see section 9)
2 For example, s-Video players
3 See section 6.4 for a description of how to connect a balanced/unbalanced stereo audio input/output
4 When less than 8 outputs are required, connect only those outputs of the VS-808YC that are required, and leave the other
outputs unconnected
5 We recommend that you use only the power cord that is supplied with this machine