Kramer Electronics VP-88K - Manual (Page 31)

Controlling the VP-88K
27 27
5. Set the Machine number on all VP-88K units other than Machine 2 to a
unique number between 3 and 16 (see Section 6.5 ) 1 . Figure 22 shows the DIP-
switch setting for Machine 2.
8.3 Controlling the VP-88K via Ethernet
Before trying to control the VP-88K via Ethernet, the unit must first be configured
according to the instructions in Section 6.4
To control the VP-88K via Ethernet:
.
Figure 23: Controlling the VP-88K via Ethernet
1. Connect the Ethernet port on Machine number 1 to the LAN port of your PC
either:
• Via a network switch (as shown in Figure 23 )
• Using a straight-through cable directly using a crossover cable
2. Set the Machine number on the VP-88K to be Machine 1 (see Section 6.5
1 Set the first unit to Machine number 2, the second unit to Machine number 3, and so on up to 16
).