Kramer Electronics VP-88K - Manual (Page 28)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VP-88K
24
Figure 19: Status Display Showing OUTPUT 8, Gain -4.5
3. Press either the (+) button to increase or the minus (–) button to increase or
decrease respectively the gain level setting.
The display changes accordingly.
4. Press either the Audio or Video button to exit the gain level setting mode. If
no button is pressed for 10 seconds, the VP-88K automatically exits the gain
level setting mode and the display reverts to normal operation.
The factory default audio gain is set to 0dB. An audio gain value of 0dB indicates
that the output signal value is identical to the input signal value. When
increasing/decreasing the audio gain, the output signal level is higher/lower than
the input signal level.
Gain level values are relative since the audio input signal can also be adjusted
independently of the output level adjustment.
7.8 Resetting the Unit
To reset the unit:
• Press and hold the Reset button on the rear panel while powering on the
device.
The device resets and a Status display self-test is performed (see Section 7.4.1
7.9 Selecting the Genlock Source
)
The button on the rear panel marked EXT/IN (see item 5 on Figure 2 ) selects the
Genlock source. When pressed in, the Genlock signal is taken from the EXT
SYNC connector situated alongside the Genlock source button (see Figure 20 ).
When the switch is released (in the out position), the Genlock is taken from the
video input 1 vertical signal.
Figure 20: Genlock External Connector and Source Selector Button