Kramer Electronics VP-88K - Manual (Page 27)

Operating the VP-88K
23 23
2. Press the appropriate INPUT/OUTPUT SELECTOR button (the INPUT
SELECTOR button number corresponding to the setup number).
The memory recalls the stored data from that reference.
7.6.3 Deleting an Input-Output Configuration
To delete an input-output configuration:
1. Press the STO and RCL buttons simultaneously.
The STO and RCL buttons flash.
2. Press the appropriate INPUT SELECTOR button.
The specific input-output configuration is erased from the memory, leaving it
empty and available 1
7.7 The Audio Input/Output Gain Control
.
The audio gain control is configured when the machine is in AUDIO or AFV mode.
The default audio gain level for all inputs and outputs is 0dB. Each input or output
can be set independently.
To set the gain level of an input or output:
1. To enter the audio gain setting mode, do either of the following:
 Press either of the Audio Level buttons and press the required INPUT or
OUTPUT SELECTOR button
 Press the required INPUT or OUTPUT SELECTOR button.
If an OUTPUT was pressed, the display indicates which OUTPUT is
selected by flashing the selected number. In this example, OUTPUT 8 is
selected (see Figure 18 ).
Figure 18: Status Display OUTPUT 8 Flashing
2. Press either the plus (+) button to increase, or the minus (–) button to decrease
the current gain level setting.
The display changes to indicate (see Figure 19 ):
 whether an INPUT or OUTPUT is selected (in this example, OUTPUT)
 which channel number is selected (in this example, 8)
 the current gain setting (in this example, -4.5)
1 Storing a new configuration over a previous configuration (without deleting it first) replaces the previous configuration