Kramer Electronics VP-1201 - Manual (Page 9)

Connecting a VP-1201 12x1 XGA Switcher / Scanner
5
Table 3: VP-1201 Underside Panel Features
# Feature Function
1 RESET Button Press to reset the unit prior to a firmware upgrade (see section 5.8)
2 GREEN LEVEL Trimmer Adjusts the green level 1
3 RED LEVEL Trimmer Adjusts the red level 1
4 BLUE LEVEL Trimmer Adjusts the blue level 1
5 Connecting a VP-1201 12x1 XGA Switcher / Scanner
This section describes how to:
Connect the VP-1201 unit (see section 5.1)
Connect the VP-1201 to a controlling device via:
RS-232 (see section 5.2)
RS-485 (see section 5.3)
ETHERNET (see sections 5.4 and 5.6)
Connect several VP-1201 machines (see section 5.5)
Set the dipswitches (see section 5.7)
Reset the unit (see section 5.8)
5.1 Connecting a Single Unit or Multiple VP-1201 Units
To connect the VP-1201 12x1 XGA Switcher / Scanner, do the following:
1. Connect the following to the rear panel:
Video sources (see Figure 3)
Output acceptor
Power cord
2. Connect to a controlling device (optional – see sections 5.2, 5.3 and 5.4).
3. Connect the RS-485 port to additional units (optional – see sections
5.5.1 and 5.5.2).
4. Connect the BUS ports to additional units (optional – see section 5.5.2).
5. Set the dipswitches (see section 5.7).
1 Insert a screwdriver into the small hole and carefully rotate it to adjust the level