Kramer Electronics VP-1201 - Manual (Page 35)

Operating the VP-1201
31
5.7.6 FLASH PROG Dipswitch Setup
Set the FLASH PROG dipswitch to ON only when upgrading to the latest
Kramer firmware (see section 7.2). Following the firmware upgrade, set to OFF.
5.8 Resetting the Unit
Push the RESET button, located on the underside of the unit, only prior to
upgrading to the latest Kramer firmware (see section 7.2).
6 Operating the VP-1201
The VP-1201 can operate in two different modes:
Switcher mode – inputs are selected manually. Move from one signal to
another by pressing the appropriate input button.
Scanner mode – inputs are automatically scanned in sequence.
6.1 Switching between Modes
To toggle from the Switcher mode to the Scanner mode, do the following:
1. Set the SCAN dipswitch to ON (see section 5.7.3.1).
2. Set the DWELL TIME dipswitch as desired (see section 5.7.4).
3. Set the VALID ONLY dipswitch as desired (see section 5.7.5).
Toggle from the Scanner mode to the Switcher mode in the reverse order.