ADTRAN MX2800 M13 - Manual (Page 56)

3-16 61200290L1-1G
Section 3, Configuration MX2800 M13 Multiplexer User Manual
4. SYSTEM MANAGEMENT
Configure the MX2800 for management through SNMP, Telnet, or a VT100 interface. See Figure 3-12 on
page 3-16. Embedded SNMP and Telnet are available via a SLIP/PPP modem port or 10Base-T Ethernet
interface. This menu also includes options used to customize the unit’s alarm and trap generation, security
setup, and equipment identification. The fields of the System Management Configuration menu vary
depending upon the configuration of the options in the shelf.
Figure 3-12. System Management Configuration Menu
CAUTION
Configuration changes to Local IP Address, Gateway IP Address, Subnet
Mask, and IP Hosts will not be implemented unless all Telnet sessions are
closed. Changes made while Telnet sessions are active will invoke a
warning message on the console.
NOTE
If the unit is not equipped with an internal modem, Dialup Option will not
be available.