Section 7, circuit and network redundancy, Introduction, Nonredundant mode – ADTRAN MX2800 M13 User Manual
Page 117: Section 7 circuit and network redundancy -1, Introduction -1, Nonredundant mode -1, Figure 7-1. nonredundant mode -1, Section 7, Circuit and network redundancy
61200290L1-1G
7-1
S
ECTION
7, C
IRCUIT
AND
N
ETWORK
R
EDUNDANCY
Section 7
Circuit and Network Redundancy
1. INTRODUCTION
The MX2800 provides backup measures of protection for circuit failure. The following subsections
describe the possible modes of operation:
•
on page 7-1 offers no backup protection
•
on page 7-2 furnishes backup protection in the event of controller card
failure
•
Circuit and Network Failure Recovery Mode
on page 7-3 provides the most complete mode of circuit
and network protection.
The descriptions given include illustrations and suggested configuration settings.
NOTE
The settings may need modification based on your network configuration.
2. NONREDUNDANT MODE
In Nonredundant Mode, the MX2800 houses only one controller card. There is no failure protection. In the
event of a failure, an alarm is initiated and the front panel LEDs reflect the condition. See
page 7-1 for an illustration.
Figure 7-1. Nonredundant Mode