Bell & Gossett P5002169C Series VSCS - Manual (Page 6)

4
ADDITIONAL SAFETY INSTRUCTIONS
Electrical Safety
WARNING: Electrical Shock Hazard
Electrical connections to be made by a qualified
electrician in accordance with all applicable codes,
ordinances, and good practices.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage.
WARNING: Electrical Overload Hazard
Three-phase motors must have properly sized
heaters to provide overload and under voltage
protection. Single-phase motors have built-in
overload protectors.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage
Thermal Safety
WARNING: Extreme Temperature Hazard
If pump, motor, or piping are operating at
extremely high or low temperatures, guarding or
insulation is required.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage.
Mechanical Safety
WARNING: Unexpected Startup Hazard
Disconnect and lockout power before servicing.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage.
WARNING: Rotating Components
Hazard
Do not operate the pump without all guards in
place.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage.
WARNING: Excessive System Pressure
Hazard
The maximum working pressure of the pump is
listed on the nameplate. Do not exceed this
pressure.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage.
WARNING: Excessive Pressure Hazard
Volumetric Expansion
The heating of water and other fluids causes
volumetric expansion. The associated forces may
cause failure of system components and release
of high temperature fluids. This will be prevented
by installing properly sized and located
compression tanks and pressure relief valves.
Failure to follow these instructions could result in
serious personal injury or death, or property
damage.