Goulds Pumps 3700 - IOM User Manual
Page 85
Maintenance
f)
Coat the internal bearing surfaces with lubricant to be used in service.
119A
Thrust end cover
123
Deflector
228
Bearing frame
360
Radial-bearing end-cover gasket
370P
Bearing-frame screws
3. Press the radial INPRO oil seal into the radial end cover.
4. Install the radial-bearing end cover and new end-cover gasket on the bearing frame.
Make sure that the expulsion part is at the 6 o'clock position and is properly seated.
For the optional air-cooling package, the radial-heat flinger replaces the standard radial
INPRO.
5. Perform the following based on your pump version:
If your pump is...
Then...
SA or MA
Press the radial INPRO oil seal into the bearing frame and make sure
that the expulsion part is at the 6 o'clock position and is properly
seated.
SX, MX, LA, LX, XLA, XLX,
Install and tighten the radial-end cover bolt and bearing-frame screws
or XXL
evenly to the torque values shown in the Maximum torque values for
3700 fasteners table.
Model 3700, API Type OH2 / ISO 13709 1st and 2nd Ed. / API 610 8/9/10/11th Ed. Installation, Operation, and Maintenance
83
Manual