Pathway Pathport Manager 5 User Guide - Manual (Page 31)

Pathway Connectivity
Pathport Manager 5 v1 Manual 31
Base Node Property Definitions
Name Definition
Name Node name – user assignable
MAC Address Media Access Control address – factory assigned
IP Address Internet Protocol (IPv4) Address – editable
IP Subnet Mask IP subnet mask – editable
IP Default Gateway IP address of system router – not typically used
Firmware Version Current operating firmware number
Identify Node Enabling causes node to flash screen or LEDS
Node Serial Number Factory-assigned serial number
Enable Keypad Lockout Enable/Disable any front panel keys
Enable LCD Backlight Turns LCD screen backlight on or off
LED Intensity Uno only. Toggles between Bright and Dim
Universe Select Lockout Jumper
Uno and eDIN only. Reports if universe jumper is set,
and to what universe (1-4)
Enable IrDA Port Feature no longer supported in firmware
Receive Artnet Enable/disable Artnet
Receive E1.31 Streaming ACN Enable/disable sACN
Receive ETC Net2 Enable/disable ETC Net2 (one- and two-ports only)
Receive Pathport Protocol Enable/disable Pathport
Receive Shownet Enable/disable Shownet
Transmit Network Protocol
Select input protocol from drop down. Choices are
Artnet, Pathport, Shownet and streaming ACN.
ArtNet Alternate Mapping
Toggle between Artnet universe 0-0 shown as Univ 1 or
ignore Artnet universe 0-0 altogether
E1.31 Transmit Version Toggle between Draft 20 and ANSI Final Release
sACN Input Priority
Toggle between ignore sACN input priority schemes or
accepting sACN input priority (disables other protocols)
Has Terminal Blocks Informational
Is Rack Mounted Informational
ETCNet2 Admin Multicast
Address
Future use
ETCNet2 EDMX Multicast
Address
Future use
Bootp Deselect for static IP. Select to seek for Bootp server
Bootp Timeout (seconds)
# of seconds a node seeks for Bootp server before
completing boot up with last used IP address
Force Dynamic IP
Forces node to wait for IP address from DHCP or Bootp
server. Node will hang if no server present. Not
recommended for most installations
Do TFTP Upgrade
Forces node to wait for IP address from DHCP or Bootp
server, then request firmware file during boot up. Node
will hang if no server present, or server doesn’t have
firmware file. Not recommended for most installations.
Note: Pathport Manager 5 does not provide a Bootp or DHCP server.