Hawk Industries Hawkjaw Sr. 100K-2GSR M100K Serial Numbers 141 to 200 - Manual (Page 62)

Tools Required
Two 11/16” wrenches, Two 1 1/2”
wrenches
Initial Steps
1. Make sure the HawkJaw is off the
drill pipe connection and in the
rest position on the derrick.
2. Follow Steps 1-4 on p. 52.
Middle Grip Cylinder
1. Use the Two 11/16” wrenches to
slowly loosen the Rod side Hose
(RH).
Check for fluid flow.
Bleed any pressure. Disconnect
the Rod side Hose (RH).
2. Use the Two 11/16” wrenches to
slowly loosen the Cap side Hose
(CH).
Check for fluid flow.
Bleed any pressure. Disconnect
the Cap side Hose (CH).
3. Use the Two 1 1/2” wrenches to
remove the Grip Cylinder Cap
side
Bolt (CB) and Lock
Washers.
4. Use the 1 1/2” wrench to remove
the Grip Cylinder Rod side Bolt
(RB) and Lock Washers.
5. Slide out the Grip Cylinder (C).
E
C RB CB
CH RH
60 Maintenance & Repair
Changing the Grip Cylinder Changing the Grip Cylinder