Hawk Industries Hawkjaw Sr. 100K-2GSR M100K Serial Numbers 141 to 200 - Manual (Page 38)

Tools Required
3/4” wrench, See Drawings.
INITIAL STEPS
1. Make sure the HawkJaw is off
the drill pipe connection and in
the
rest position on the derrick.
2. Shut down the Hydraulic power
unit.
3. Press the Grip button
repeatedly
to bleed hydraulic
pressure.
4. Disconnect the Air power
supply.
5. Push in the “E” stop.
6. Assume that there is still a load
on every actuator. Proceed with
caution.
Hook Dies
1. Use the 3/4” wrench to remove
the
Die Holder Bolts (B).
Remove the Die Retainer (DR).
2. Slide out the worn Die (D).
3. Make sure the back and sides of
the
new Die are clean.
4. Grease the back of the new Die.
5. Insert the new Die into the Die
Holder (DH) with the teeth of
the Die facing out.
6. Replace the Die Retainer (DR).
Use the 3/4” wrench to replace
the
Die Holder Bolts (B) and
Lock Washers.
Changing the Hook Dies Changing the Hook Dies
36 Maintenance & Repair
Part Numbers
Part Name Part #
Die (D) 061- 20194
Die Holder Bolt (B) 999- 806245
Spirol Lock Washer 999- 810703
Die Holder (DH) 061- 20192B
B
DR
DH D