Changing the torque cylinder – Hawk Industries Hawkjaw Sr. 100K-2GSR M100K Serial Numbers 141 to 200 User Manual

Page 57

6. Use the 1 1/8” wrench to slowly
loosen

the Cap side Hoses

(CH1), (CH2). Check for fluid
flow. Bleed any pressure.
Disconnect

the Cap side Hoses

(CH1), (CH2).
7. Use the 1” wrench to slowly
loosen

the Rod side Hose (RH).

Check

for fluid flow. Bleed any

pressure. Disconnect the Rod
side

Hose (RH).

8. Pull out the Torque Cylinder
Safety Clip (SC).
9. Use the Torque Cylinder Safety
Clip

(SC) to pull out the Torque

Cylinder Rod Pin (P).
10. Disconnect the Low Torque
Warning System Hydraulic Hoses
(HH & HH1).
11. Use the 1 1/8” wrench and 5/8”
Allen wrench to remove the Top
Torque Cylinder Mount Bolts
(TBH), (TBA).
12. Use the 1 1/8” wrench to remove
all Four Bottom Torque
Cylinder Mount Bolts (BB).
13. Slide out the Torque Cylinder (C).
14. Remove the Bottom Trunion
Mount

Plate (BMP) and the Top

Trunion Mount Plate (TMP).

Continued on next page...

Maintenance & Repair 55

Changing the Torque Cylinder