Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 - Manual (Page 46)

Lubricant Required
Chevron Pinion Grease Spray
(Part # MS-SP), 7/16" wrench
Spinner Maintenance
1. Connect the air and hydraulic
power units to the HawkJaw. See
Operation, p. 14.
2. Use the 7/16" wrench to remove
the rubber Safety shield bolts (B).
3. Remove rubber Safety shield (S).
4. While spinning after break out, from
the back of the spinner, apply
spray to chain.
5. Replace rubber Safety shield (S).
6. Use the 7/16" wrench to replace the
rubber Safety shield bolts (B).
Grease Once per Week
Chain
B
S
WARNING
Run spinner only when gripped on a
pipe body.
WARNING
Never under any conditions apply
weight materials or any other dry
materials to the chain.
NOTE
The middle or bottom Grip button must be pushed in
before the Spinner will operate.
46 Maintenance & Repair
WARNING
Keep hands away from the main drive sprocket while
spraying the chain.