Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 - Manual (Page 31)

Break Out
1. Follow the steps on pages 14, 24-
30.
2. Push in the wrench Grip (G).
3. Push and hold down Torque (T).
4. When break out occurs, release
Torque (T). Immediately release
the wrench Grip (G).
5. If the connection does not break
out, continue to hold down Torque
(T) and get another crew person to
rotate the Torque Set knob (K)
clockwise until the connection
breaks out. When break out
occurs, release Torque (T).
Immediately release the wrench
Grip (G).
6. Press and hold down Spin (S) until
the stand pops out of the connec-
tion. Release Spin (S). If the
stand will not spin, release Spin
(S). Repeat Steps 3-7.
7. You are now able to remove the
Hawkjaw from the pipe.
S T
K
31 Operation
NOTE
If the spinner will not open and allow the Hawkjaw to
release from the pipe, you have pulled out the bottom
grip button before releasing the spin button. To
release the Hawkjaw from the pipe, push in the
middle grip button, and the spinner will open. Now
release the middle grip button and remove the
Hawkjaw from the pipe.
G
Operation