Hydraulic filter maintenance – Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 User Manual

Page 37

Hydraulic Filter Maintenance

Change Every 2 Months

Initial Steps

1. Depress the Red button (RB)

located under the See-through
rubber weather cap (SC).

2. Operate the HawkJaw.
3. If the Red button pops up,

proceed with Step 4.

4. Make sure the HawkJaw is off the

drill pipe connection and in the rest
position on the derrick.

5. Shut down the Hydraulic power

unit.

6. Press, push, and pull all control

buttons repeatedly to bleed
hydraulic pressure.

7. Disconnect the Air power supply.
8. Press, push, and pull all control

buttons repeatedly to bleed air
pressure.

9. Assume that there is still

pressure in the Pressure Line.
Proceed with caution.

Hydraulic Filter

1. Remove the Filter Cannister (C).
2. Remove the Filter Element (E).
3. Insert the new Filter Element.
4. Replace the Filter Cannister (C).

Part Numbers

WARNING

Running the HawkJaw

without a Hawk approved

pressure-side filter (Part #

061-H25) voids the

warranty and severely

shortens component life.

NOTE

If the Cannister (C)

leaks, change the

"O" ring and back-

up (S).

Maintenance & Repair 37

Maintenance

Repair

Part Name

Part #

Filter

061-H25

Filter Element (E)

061-H25A

Filter Cannister/Body (C) 061-H25B

Weather Cap (RB)

061-H25C

Filter Seal Kit (S)

061-H25SK