American Electric Lighting CVL User Manual

Installation instructions

INSTALLATION INSTRUCTIONS

CORVUS LARGE (CVL)

POWERPAD

REMOVAL & INSTALLATION:

1. Open the ballast door. (See “OPENING AND CLOSING THE
UNIT” above.)

2. Unscrew the four screws attaching the power pad to the unit,
totally disengaging them from the casting.

3.Gripping the bracket, remove the power pad from the unit,
disconnecting the wiring by use of the quick disconnect.

4. To reinstall the power pad repeat the steps above in reverse
order.

Note: Check to insure that the wires are not pinched against the
casting during re-installation of the power pad.

OPENING & CLOSING THE UNIT:

1. To open the fixture, locate the latch at the top of the ballast
door and flip it to open compartment. (See Figure 1.)

2. Open ballast door.

3. To open the optic compartment simply locate the bezel latch
and flip it.

4. Open optic compartment

DRAWING NO. A68046 REV. -

PART NO. 057-71-68046

2007 ACUITY LIGHTING GROUP, INC.

(Figure 1.)