American Electric Lighting Series 11 & 11 Package User Manual

Installation instructions series 11 & 11 package, Warning, Warning caution

INSTALLATION INSTRUCTIONS

SERIES 11 & 11 PACKAGE

American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA

DRAWING NO. A71964 REV A (FRONT)

PART NUMBER 057-71-71964

1. FEED THE FIXTURE WIRES THROUGH THE MOUNTING

ARM, SLIDE THE FIXTURE ONTO THE MOUNTING ARM

UNTIL IT IS FULLY ENGAGED, AND TIGHTEN THE FITTER

BOLTS "A" SECURELY.

2. LEVEL FIXTURE USING STEPS SEE ILLUSTRATION.

1. FASTEN THE MOUNTING ARM AND CLAMP ASSEMBLY INTO

PLACE, USING THE FOUR LAG SCREWS SUPPLIED. TIGH-

TEN THESE SCREWS SECURELY.

INSTALLING THE MOUNTING ARM

INSTALLING THE OPTICAL ASSEMBLY & LAMP

DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.

HOUSING MUST BE GROUNDED TO REDUCE POTENTIAL OF ELECTRICAL SHOCK

READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION

WARNING

TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL

APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. FOR CODE INTERPRETATION,

CONSULT LOCAL CODE AUTHORITY BEFORE INSTALLING VERIFY THAT THE SUPPLY VOLTAGE

MATCHES THAT REQUIRED BY THE FIXTURE AS SPECIFIED ON THE DATA LABEL.

RISK OF FIRE. PRODUCT FOR OUTDOOR INSTALLATION AND USE ONLY.

WARNING

CAUTION

THE MOUNTING ARM IS NOT DESIGNED TO

SUPPORT THE WEIGHT OF A PERSON.

1. FOR OPTIC WITH LATCH OPTION. ATTACH SPRING LATCH

OF OPTIC TO THE TABS ON THE SIDE OF THE HOUSING

PULL LATCH HANDLE DOWN TO LOCK IN PLACE.

2. SCREW BULB INTO BULB SOCKET UNTIL BULB IS FIRMLY

SEATED.

NOTE FOR MH LAMP WIRE MESH MUST BE INSTALLED

TO MITIGATE POTENTIAL FOR NON-PASSIVE FAILURE

OF MH LAMP.

MOUNTING THE FIXTURE

WARNING

THE FIXTURE IS SUPPLIED WITH A STANDARD LAMP,

WHICH CAN CAUSE SERIOUS SKIN BURNS AND EYE

INFLAMMATION IF IT IS OPERATED WHEN THE OUTER

GLASS JACKET OF THE LAMP IS BROKEN. IF THE GLASS

SHOULD BREAK DURING OPERATION, DISCONNECT THE

POWER TO THE FIXTURE AND REPLACE THE DEFECTIVE

LAMP IMMEDIATELY. TO INSTALL THE LAMP, SCREW IT

INTO THE LAMP SOCKET UNTIL IT IS FIRMLY SEATED

MAST ARM

2" WASHER

2-1/4" WASHER

NOTE: 2-1/4" SPECIAL ONLY

BOLT WITH NUT

4" LAG BOLT (1) (2)

3" LAG BOLT (1) (2

))

WASHER

BOLT

LEVELING STEPS

MAST ARM

OPTIONAL