American Electric Lighting 325 fg new User Manual

Type iiimc type iimc

325 SERIES HORIZONTAL LUMINAIRE

INSTALLATION INSTRUCTIONS

American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA

DRAWING NO. B62853 REV E

PART NUMBER 057-71-62853

TYPE IIIMC

TYPE IIMC

TERMINAL BLOCK. VERIFY THAT SUPPLY VOLTAGE IS CORRECT

AS NOTED ON THE TERMINAL BLOCK LABEL. REFER TO THE WIRING

INFORMATION AND RATINGS.

DIAGRAM AND THE DATA ON THE BALLAST FOR CONNECTION

CLEAN OR REPLACE AS DESIRED.

SUPPORT THE REFRACTOR AT ALL TIMES. REMOVE REFRACTOR

HOUSING". ROTATE THE REFRACTOR LATCH BEING CAREFUL TO

OPEN THE LOWER DOOR AS OUTLINED UNDER "REMOVE LOWER

REFRACTOR REPLACEMENT

DETERGENT AND RINSED WITH CLEAN WATER TO MAINTAIN EFFICIENCY.

THE OPTICAL ASSEMBLY SHOULD BE CLEANED WITH A MILD

MAINTANCE AND CLEANING

AND TIGHTEN SCREW.

LOOSEN THE SCREW (DO NOT REMOVE) SLIDE TO NEW POSITION

SOCKET ADJUSTMENT

AND CONNECT THEM TO THE PROPER TERMINALS ON THE

THEM SO THEY DO NOT INTERFERE WITH ANY COMPONENTS,

FEED THE SUPPLY WIRES THROUGH THE MAST ARM, DRESS

WIRING

BOLTS TO 10 ft. lbs.

THE FRONT ONES. WHEN THE LUMINAIRE IS LEVEL, TORQUE

HIGH, LOOSEN THE TWO REAR FITTER BOLTS AND TIGHTEN

UNTIL THE LUMINAIRE IS LEVEL. IF THE FRONT END IS

TIGHTEN THE TWO REAR ONES. REPEAT THIS PROCEDURE

IS LOW, LOOSEN THE TWO FRONT FITTER BOLTS AND

MAST ARM UNTIL IT IS LEVEL. IF THE FRONT END

FROM SIDE TO SIDE, TWIST THE LUMINAIRE ON THE

THE LUMINAIRE. IF THE LUMINAIRE IS NOT LEVEL

PLACE A LEVEL ON THE AREA PROVIDED ON TOP OF

LEVELING

BOLTS FINGER TIGHT.

LUMINAIRE ON TO MAST ARM TO STOP AND TIGHTEN

MOUNTING LUMINAIRE ON A 2" MAST ARM. SLIDE

REMOVE CENTER OF BIRD SHIELD IF YOU ARE

1 1/4" MAST ARM & 1 1/4" FOR 2" MAST ARM.

LOOSEN FITTER CLAMP BOLTS. ABOUT 1/2" FOR

MOUNTING/LEVELING

LIFT OFF UPPER HOUSING.

LATCH. ROTATE LOWER HOUSING ABOUT 140° AND

OPEN LOWER HOUSING BY PULLING ON FRONT TRIGGER

REMOVE LOWER HOUSING

UPPER HOUSING

TRIGGER LATCH

BEZEL DOOR

REFRACTOR

1/4" SCREW

BALLAST DOOR LATCH

BALLAST DOOR

LIGHT DISTRIBUTION

200-400W HPS
200-400W HPS

IIMC
IIIMC

2
3

UNLESS OTHERWISE SPECIFIED, SOCKET SETTINGS AT

THE FACTORY ARE ADJUSTED FOR CLEAR LAMPS.

FLAT GLASS
FLAT GLASS

WATTS

LENS

IES TYPE

SOCKET POSITION