You can check and manage data files recorded by the PW100.
Display 1 indicates the remaining amount of storage (%). Display 3 indicates the total number of laps used
in that data file. Display 4 indicates the data file number.

NOTE:

• Power-related measurement data are stored in the power unit while other measurement data

are stored in the main unit. Therefore, before deleting data files, make sure to attach the main
unit to the power unit. If data files are deleted using the main unit only, power-related data will
not be deleted, resulting in a malfunction.

If data files are deleted using the main unit only, refer to “Trouble on operation” on page 64.

• To check and use the stored data files, a PC is required.

• When there are no date files recorded (

“F-0”

on Display 4), this screen cannot be operated.

Remaining memory

Data file menu

screen

Data file

number

Number of

laps used

Number of
laps used
in file

Memory consumption

Recording interval

Alternating data display

Data file check screen

Switch file

File number

Date of ride

Ride time

Ride start time

End

Haert rate sensor ID menu screen

• Checking data files

When the START/STOP/ENTER button is pressed with the “Data file” menu displayed, data files
can be checked.
The screen displays the data file number, recording interval, memory consumption, number of
laps, date and time when the file was recorded, and exercise duration.
To switch the data file number, press MODE-1 or MODE-2.

NOTE:

• Up to 99 data files can be stored until the remaining memory is at 0%.
• When the remaining memory reaches 0% while data storge is in progress, your data

file will end at that point. Measurement continues, however, data is no longer stored
in a data file. New data files will not be created.

• If data is downloaded after the power unit is connected to the PC, “data relocation”

occurs. Consequently, the data file in the main unit is deleted.
(This setting can be changed to “data copy”. For further information, refer to “Down-
loading measured data” in the electronic “e-Train Data v3E. pdf” documentation.)