Manual odometer input, Speed unit, Defining remote button setting – CatEye PW-TR100 Power Unit User Manual
Page 40: Menu screen, Operation guide
MODE-
1
MODE-
2
MODE-
2
MODE-
1
40
PW-TR100 : POWER UNIT
Defining remote button setting
* For the basic information on
how to use the menu screen, re-
fer to “Configuring main unit”
on page 35.
Menu screen
Operation Guide
MODE-
2
S/S/E
MODE-
1
MODE-
1
S/S/E
MODE-
1
or
MODE-
2
K : km/h
M : mph
S/S/E
S/S/E
MO-1
MO-2
S-S
LAP
Lt
MODE-
2
MO-1
MO-2
S-S
LAP
Lt
MODE-
2
S/S/E
S/S/E
S/S/E
MODE-
1
Manual odometer input
Enter any numeric value as the “odometer value (Odo)”. This allows the input of past data even when data
has been erased by formatting or when replacing from another cycle computer.
Odometer value cannot be changed while the bicycle is in motion.
Speed unit
Switch between speed units between km/h and mph. After switching, the odometer value is converted into
the new unit automatically.
NOTE:
Before changing units, you must stop the bicycle and reset all measured data.
Defining remote button setting
Specify the functions the functions to be assigned to buttons 1 and 2. In the initial setup, button 1 is
assigned to MODE-1 and button 2 to MODE-2.
Setting clock menu screen
Cadence zone menu screen
Manual odometer
input menu screen
Digit shift
Select
Select
Speed unit
menu screen
Defining remote button
setting menu screen
Select button 1
Select button 2
Select
Select
MO1 = MODE-1
MO2 = MODE-2
S-S
= START/STOP/ENTER
LAP
= LAP
Lt
= LIGHT