Main unit set-up, Pull out battery insulation sheet, Formatting / restarting operations – CatEye PW-TR100 Power Unit User Manual
Page 12
12
PW-TR100 : POWER UNIT
Start Guide
RESTART
MENU
RESTART
Main unit set-up
Before using the Power Unit, follow the procedure below to set up the main unit.
If your CC-TR100 has already been set up, start from “6. Specifying the Power select option” on page 15.
1. Pull out battery insulation sheet
Using a coin, open the battery cover of the main unit and pull out the insulation sheet, then close the
battery cover.
CAUTION !
When closing the battery cover, be careful not to pinch the seal.
Doing so may adversely affect the splash-proofing seal and result in a malfunction.
2. Formatting / restarting operations
Before formatting/restarting operations, attach the main unit to the power unit.
NOTE:
Be sure to attach the main unit to the power unit.
If formatting or a restart is carried out using the main unit only, unnecessary data may remain in
the power unit, resulting in a malfunction.
Formatting
Formatting is required during the initial set- up, and when all items of data are to be reset to zero.
NOTE:
Formatting operation initializes all of the data in the memory. Be absolutely certain that you want
to initialize all of the data.
When all items light up for a few seconds and formatting is completed, proceed to the heart rate sensor ID
check screen.
Insulation sheet
Press the RESTART button while
pressing and holding the MENU
button; then release the RESTART
button only.
When a beep sounds, release the
MENU button.
All items displayed
After a few seconds have
elapsed, proceed to the
heart rate sensor ID check.
Press the RESTART button
All items displayed
(for 1 sec.)
To heart rate sensor ID check
NOTE:
If there is little memory available, all screen items may remain on for approximately one minute.
Restart
You must restart the computer when you replace the batteries, or when an error has been displayed.
When the RESTART button is pressed, all of the items light up for one second. You will then proceed to
the heart rate sensor ID check screen.
NOTE:
In the restart operation the date, total time, and total distance are retained, but the heart rate
sensor ID check and time settings must be performed again.
Close
Open
Seal
Main unit
Power unit