CatEye PW-TR100 Power Unit - Manual (Page 22)

22
PW-TR100 : POWER UNIT
Start Guide
START/STOP/ENTER
LAP
MODE- 2 MODE- 1
S/S/E
START/STOP/ENTER
LAP
MODE- 1
S/S/E
START/STOP/ENTER
LAP
MODE- 1
S/S/E
Resetting operation
Follow the directions below for resetting selected data to zero.
NOTE: • Make sure to reset with the main unit attached to the power unit.
If a reset is carried out using the main unit only, unnecessary data may remain in the power
unit, resulting in a malfunction.
If a reset is carried out accidentally using the main unit only, refer to “Trouble on operation”
on page 64.
• You cannot perform the resetting operation on the lap screen.
1. Resetting all measured data (main and second measurements)
To zero all data except for “TTm (total time)”, “Odo (total distance)”, “date” and “time”, and including
the lap data and time in the heart rate and cadence zones, simultaneously press the START/STOP/
ENTER, MODE-1 and MODE-2 buttons.
NOTE:
When resetting is required to change the settings on the menu screen, reset all measurements.
2. Resetting the main measurement data
To zero the main measurement data except for “TTm (total time)”, “Odo (total distance)”, “date” and
“time”, and including the lap and the time in the heart rate zone and cadence zone, simultaneously press
the START/STOP/ENTER and MODE-1 buttons while the main measurement is displayed.
3. Resetting the second measurement data
To reset to zero all erasable data in the second measurement display only, simultaneously press START/
STOP/ENTER and MODE-1 while the second measurement icon is on.
Power-saving function
When the computer has not received any data for 10 minutes, the main unit will enter the power-saving
mode, in which only the clock is displayed (note illustration).
When speed, cadence, or power signal is entered, or when any button is pressed, the power-saving func-
tion is canceled and the normal display reappears.
NOTE: The power-saving mode is not cancelled if the computer receives a heart rate signal.
Main
measure-
ment display
Second
measure-
ment display
Power-saving state
(after 10 minute idle)