When the MODE-1 button is pressed with the target setting screen displayed, the lower limit in
the cadence zone blinks. When the MODE-1 button is pressed again, the upper limit blinks.
When the MODE-2 button is pressed with the lower or upper limit blinking, the first digit of the
value blinks.
To change a value and shift the digit, see the illustrations below. After entering the desired value,
press the MODE-1 button to cause all the numeric characters to flash, and press the START/
STOP/ENTER button to finish the setting operation.
In the initial setup, the lower limit is set at 80 and the upper at 120.

NOTE:

• To change the upper/lower limits, the computer must be reset while the bicycle is not

in motion. Press the MODE-1, MODE-2, and START/STOP/ENTER buttons simulta-
neously to reset all measurements.

• Not resetting all measured data causes the

“PLEASE rESEt”

message to be dis-

played, making selection impossible.

• When a lower limit value greater than the upper limit value is entered, the upper limit

value is automatically adjusted to the value of the lower limit value plus one. When a
wrong upper limit value is entered, the same adjustment is made.

Changing the

lower limit value

Changing the

upper limit value

First digit

Second digit

Third digit

Digit shift

Select

First digit

Second digit

Third digit

Digit shift

Select

Reset all
measure-
ments.

Heart rate zone menu screen