CatEye PW-TR100 Power Unit - Manual (Page 15)

15
PW-TR100 : POWER UNIT
Start Guide
MODE- 2
MENU
S/S/E MODE- 1 or MODE- 2 S/S/E
6. Specifying the Power select option
The Power select option is OFF by default.
Attach the main unit and power unit to the bracket and connect the cable terminal from the battery unit to
the power unit BATT terminal.
NOTE: • Power unit, and connect the cable terminals between the power sensor and battery unit, and
between the battery unit and power unit.
• Engage the smallest gears at both front and rear so that the tension on the chain can be
minimized.
• Carry out calibration with the gear crank side facing downward.
• Do not touch the crank during calibration.
1. Press the MENU button with the Measuring screen displayed to bring up the “Wheel selection” menu
screen. Then press the MODE-2 button to bring up the “Power select” menu screen.
2. Press the START/STOP/ENTER button and then the MODE-1 or MODE-2 button to set the Power select
option to ON. When the START/STOP/ENTER button is pressed again, calibration starts and checks
whether or not the unit is connected to the power sensor correctly. After calibration has been com-
pleted, the software of the main unit is available to the power unit.
Main display Wheel selection Power select
Power select Calibration
NOTE: If the original screen reappears after an “Error” message is displayed, this may signify that the
power unit is connected incorrectly, or that the user is pedaling during calibration.
Press the MENU button again to return to the Measuring screen.
Cable terminal
BATT
terminal