Sony MVC-CD500 - Manual (Page 14)

14
Using an external power source
, Open the DC IN jack cover and
connect the AC Adaptor
(supplied) to the DC IN jack of
your camera.
Connect the DC plug with the v mark
facing up.
• Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by. If any trouble
occurs while using the adaptor, immediately
shut off the power by disconnecting the plug
from the wall outlet (wall socket).
, Connect the power cord (mains
lead) to the AC Adaptor and
then to a wall outlet (wall
socket).
• When you have finished using the AC Adaptor,
disconnect it from the DC IN jack of the
camera.
• The set is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket), even if the unit itself
has been turned off.
1
DC IN jack cover
AC Adaptor
DC plug
2
2 To wall outlet (wall socket)
Power cord
(mains lead)
1
AC Adaptor
Using your camera
abroad
Power sources
You can use your camera in any country or
region with the supplied AC Adaptor within
100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a] , if necessary, depending on the design of
the wall outlet (wall socket) [b] .
• Do not use an electronic transformer (travel
converter), as this may cause a malfunction.
AC-L15A/L15B