beautypg.com

Acer Altos G900 User Manual

Page 94

background image

3 Hardware configuration

78

The table below lists the LED states and the drive status indicated by
each state.

Installing and removing a hot-swap drive
in a carrier

To install a hot-swap drive in a carrier

Before you can install a drive in the hot-swap drive bay, you must
install the drive into a drive carrier. To install a hot-swap drive in a
carrier:

1

If the plastic air baffle is installed in the carrier, remove the four
screws that attach the air baffle to the carrier.

Save the air baffle in case you later remove a drive.

LED state

Status

Solid green

The hard drive is present and powered on.

Flashing green

The hard drive is active.

Solid yellow

There is an asserted fault status on the hard drive.

Flashing yellow

A rebuild of the hard drive is in progress.

Off

The hard drive is not powered on.

Figure 40 - Removing a plastic air baffle from a carrier

AA G900 ug - EN.book Page 78 Wednesday, September 25, 2002 5:23 PM