Acer Altos G900 - Manual (Page 68)

3 Hardware configuration 52
To install the access cover to the system boards
1 Orient the access cover with the captive screws toward the front of
the server.
2 Insert the tabs on the rear of the cover into the slots at the rear of
the chassis.
3 Press down gently and tighten the captive screws at the front of
the cover.
Memory board
To remove the memory board
1 Grasp the bracket on the top edge of the memory board and pull
straight up until the board disengages from the connector on the
processor board.
2 Lift the memory board out of the chassis.
Figure 17 - Removing the access cover to the system boards
AA G900 ug - EN.book Page 52 Wednesday, September 25, 2002 5:23 PM