Acer Altos G900 - Manual (Page 102)

3 Hardware configuration 86
To install a power supply module
1 If present, remove the filler panel from the vacant slot.
2 Holding the power supply latch handle in the open position, slide
the power supply module into the vacant slot until you feel
resistance.
Caution! The module engaging its connector causes the
resistance. To avoid damaging the module, do not tilt or twist the
power supply module as you push it into the connector.
3 Guide the power cord through the strain relief notch in the latch
handle and plug the cord into the AC power connector on the
back of the power supply module.
4 Press the latch handle down to engage the latches and secure the
power supply to the chassis.
5 Insert and tighten the four screws that secure the power supply
module to the chassis.
6 Connect the AC power cord to the wall outlet or other AC power
source.
The green LED on the power supply module should be illuminated.
AA G900 ug - EN.book Page 86 Wednesday, September 25, 2002 5:23 PM