HID VertX EVO V2000 Installation Guide - Manual (Page 7)

VertX EVO V2000 Installation Guide, 72000-902, rev A.2
April 2012 Page 7 of 18
© 2003 - 2012 HID Global Corporation. All rights reserved.
4. Output Connections (VertX EVO V2000) –
All Output connections are used for general purpose controls. The following
table shows where the various outputs are located. Pin numbers shown use the
convention “NO/C/NC”. For example, Output 1, V2000: P3 Pin 1 is NO
(Normally Open,) Pin 2 is C (Common,) and
Pin 3 is NC (Normally Closed).
Note: Relays are dry contact rated for 2Amps @ 30VDC, resistive.
Output
number
V2000
1
P3 Pins 1/2/3
Strike(lock) Relay 1
2
P3 Pins 4/5/6
Aux Relay 1
3
P6 Pins 6/5/4
Strike (lock) Relay 2
4
P6 Pins 3/2/1
Aux Relay 2
CAUTION: Some magnetic locks exhibit both high inrush current when activated and a high
instantaneous break voltage when de-energized due to magnetic field collapse. Use a snubber circuit
across the controlling relay terminals to protect the controlling relay contacts. Go to
support.hidglobal.com , see Solution 891 - How do I wire a High In-Rush Current locking device to
VertX/Edge/Edge Solo?.