Firewall, Contact information – HID VertX EVO V2000 Installation Guide User Manual
Page 14
VertX EVO V2000 Installation Guide, 72000-902, rev A.2
April 2012
Page 14 of 18
© 2003 - 2012 HID Global Corporation. All rights reserved.
5. Configure the controller for your installation parameters. See 3.1 VertX Communications, page 10.
6. Replace the V2000 cover.
Firewall
If the VertX controller is being installed where it communicates through a firewall, then the firewall may need to be
configured to allow TCP data transfer on the specified port(s).
1. Before starting, ensure that any pop-up blocker software is disabled on the computer.
2. Open the following ports on the firewall.
•
connection_port (4070) TCP outbound. This port must be open on the Host computer.
•
listen_port (4050) TCP incoming. This port must be open when using selected applications.
If you are not familiar with configuring a firewall for a network, contact the Network/IT administrator or manager.
CAUTION: If the firewall is not configured properly the controller may not communicate with the host.
Contact Information
Americas
HID Global (California, USA)
support:
support.hidglobal.com
sales:
main:
949 732 2000
sales:
800 210 4744
telephone: 800 237 7769
fax number: 949 732 2120
Europe, Middle East and Africa
HID Corporation, Ltd. (Haverhill, UK)
support:
support.hidglobal.com
sales:
telephone: +44 1440 714 850
fax number: +44 1440 714 840
Asia-Pacific
HID Asia Pacific Ltd. (Hong Kong)
support:
support.hidglobal.com
sales:
telephone: (852) 3160 9800
fax number: (852) 3160 4809