HID ProxPro Installation Guide - Manual (Page 13)

ProxPro
®
Installation Guide Part No. 5355-900, Rev N.1
¾ Clock/Data bit time 1.5ms (default)
¾ Clock/Data strobe width bit time/3 (33% of bit time), default = 500us
¾ Clock/Data clock/strobe is valid 1.5ms (one clock cycle, min) after card
present is
Asserted data is valid 10us (min) before the
negative edge of clock/strobe card present
returns to the high level 50 ms (max) after
the last clock/strobe.
9 Product Configuration/Ordering Options
5355 A G N 00 -XXXX Y
Customer Custom Artwork or Firmware Number
1 through 9, A through Z
Customer Custom Number
Configuration Options - (00 standard)
Standard Hardware Options - N = None, K = Standard Keypad
(internal or 2 of 7), S = Direct Connect Keypad (3 x 4 type), D =
Buffered Direct Connect Keypad (3 x 4 type)
Color - G = Gray, B = Beige
Model Number Suffix
Model Number 5355 = ProxPro Wiegand
Model Number 5358 = ProxPro Clock/Data
Final Assembly Number = 5355-300-XX Changes with Revisions
• FCC Compliance Statement: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: 1) This device may not cause harmful interference. 2) This
device must accept any interference received, including interference that may cause undesired
operation.
• For proper regulatory compliance, the drain wire should be disconnected at the power supply end
of the cable.
• The Reader is intended to be powered from a limited source output of a previously certified power
supply.
• Changes of modifications not expressly approved by the responsible for compliance could void the
user’s authority to operate the equipment.
Note: The above are recommended installation procedures. All Local, State and National Electrical
Codes take precedence.
February 22, 2007 Page 13 of 14
© 2007 HID Global Corporation. All rights reserved.