Spektrum DX6i - Manual (Page 19)

19 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
3. Establish the desired fail-safe stick positions: normally low throttle and flight controls neutral.
4. Pull and hold the trainer switch on the top of the transmitter while turning on the power switch. Within
a few seconds the system should connect. The LEDs on the receivers should go solid, indicating the
system has connected.
5. Remove the bind plug from the charge jack before turning off the receiver and store it in a
convenient place.
6. After you’ve programmed your model, it’s important to rebind the system so the true low throttle and
neutral control surface positions are programmed.