Spektrum DX6i - Manual (Page 15)

15 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
RECEIvER INSTAllATION
Install the main receiver using the same method you would use to install a conventional receiver in your aircraft.
Typically, wrap the main receiver in protective foam and fasten it in place using rubber bands or Velcro straps.
Alternately, in electric models or helicopters, it’s acceptable to use thick double-sided foam tape to fasten the main
receiver in place.
Mounting the remote receiver in a slightly different location, even just inches away from the primary receiver,
gives tremendous improvements in path diversity. Essentially, each receiver sees a different RF environment and
this is key to maintaining a solid RF link, even in aircraft that have substantial conductive materials (i.e. larger gas
engines, carbon fiber, pipes, etc.), which can attenuate the signal.
Using servo tape, mount the remote receiver keeping the remote antennas at least 2 inches (51mm) away from the
primary antenna. Ideally, the antennas will be oriented perpendicularly to each other, however, we’ve found this to
not be critical. In airplanes, we’ve found it best to mount the primary receiver in the center of the fuselage on the
servo tray and to mount the remote receiver to the side of the fuselage or in the turtle deck.
In helicopters, there is generally enough room on the servo tray to achieve the necessary separation. If necessary,
a mount can be fashioned using clear plastic to mount the external receiver.