Lectrical, Nstallation – Swiftech H20 120 T User Manual
Page 25
•
Dielectric grease application: This step will ensure that condensation does not form inside of the CPU socket.
Procure a tube of dielectric grease. We use Luberex grease, available on our web site here:
Figure 5
Figure 6
Squirt a generous amount of grease onto the socket.
Force the grease inside of the pin-holes with your finger. Make sure that
the central area of the socket is completely filled with grease.
To complete the condensation prevention measures, simply apply the neoprene sticker provided with your MCW5002-PT
accessories to the
back of the motherboard, directly behind the processor.
b. CPU and cooler installation:
Figure 7
Remove the peel-off paper back from the
motherboard gasket, and install it as shown above.
The sticky side should be towards the motherboard.
Insert the processor into the socket. Since you
have grease inside the socket, some hydraulic
pressure lift may occur: for this reason, make sure
that the processor sits perfectly flat, and is inserted
all the way into the socket.
Then, drop a small amount of high quality thermal
compound onto the center of the processor core.
Installation of the cooler to the motherboard is now complete!
Securing the MCW5002-PT cooler to the motherboard:
Install the MCW5002-PT
assembly onto your processor, as shown in figure 8.
Gradually tighten the screws in a cross pattern until you feel that they reach
the bottom of the standoff. A “finger-tight” lock is sufficient.
Figure 8 - (showing an MCW5000-PT)
3. Electrical
Installation
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28
th
St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content Copyright
Swiftech 2004 – Last edited 12-9-04 – Subject to revision without notice
- 25 of 37 -