beautypg.com

Parts list – barbed adapters are sold separately, Mcres-525™ r, Eservoir – Swiftech H20 120 T User Manual

Page 14: Nstallation guide

background image

P

ARTS LIST

– B

ARBED ADAPTERS ARE SOLD SEPARATELY

Parts

QTY

PARTS

QTY

MCRES-525™ Reservoir

1

Retention screws

4

Fill-cap & o-ring

1

Port plug

1


This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at

www.swiftnets.com

for

updates.

The MCRES-525™ reservoir is designed to be installed in a 5 ¼” drive bay. It features three 3/8” threaded ports (standard NPT thread)
to accommodate a number of configurations (see * Swiftech fittings). The port usage is defined as follows:

(1) Discharge port located at the “stepped-down” compartment. This port must ALWAYS be connected to the
pump inlet for the MCRES-525™ to operate properly.

(2) Inlet ports can be used interchangeably: in “single inlet” configuration (the most common), or “dual inlet”
configuration when devices are returning to the reservoir in parallel. One port plug is provided to seal one of the
inlets in order to accommodate the most common “single inlet” configuration.


The following guide assumes that all liquid cooling components in your system, such as radiator, pump, and water-block(s) have been
already installed, and the graphic below shows an overview of a typical installation.

Swiftech Fittings & Spare parts

Important! All fittings (except DP-11) require sealant: plumbers tape, or plumbers goop (preferred)

A6-8

A6-6

PI011623S

DP-11

P6N

1/2" barb to 3/8" NPT, for 1/2"
Inner diameter tubing (3/4" or
5/8" outer diameter) – Order
Separately

3/8" barb to 3/8" NPT, for
3/8" Inner diameter tubing
(1/2"outer diameter) – Order
separately

3/8” NPT to ½” tube (outer
diameter) quick-connect
fitting – Order separately

Fill-cap & o-ring


Included

3/8” NPT Port
plug

Included

Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28

th

St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All

content Copyright Swiftech 2004 – Last edited 9-27-04 – Subject to revision without notice

- 14 of 37 -