Swiftech H20 120 T - Manual (Page 15)

Installation guidelines
Figure 1: Always leave sufficient slack in the lines to pull enough
of the reservoir out of the drive bay and uncover the fill port. Figure 2: You can start filling up the reservoir while it is in the drive
bay, using a household funnel. Then, start-up the pump and top-off
the reservoir as needed. With this method, you will be able to fill-up
the reservoir to its minimum operating level, as shown figure 3.
Figure 3: The minimum operating fluid level is at the mould
parting line. Figure 4: If possible or desired, you can also fill the reservoir outside
of the chassis. Tipping it steeply at an angle will allow you to fill-it up at
the maximum operating level as shown figure 5. Do not forget to close
the fill-cap before you re-install the unit into the drive bay!
Figure 5: Desired (Maximum) operating fluid level Figure 6: Once full, secure the reservoir to the drive-bay with the
provided screws. Installation is complete!
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content
Copyright Swiftech 2004 – Last edited 12-9-04 – Subject to revision without notice - 15 of 37 -