Allied Telesis AT-S63 - Manual (Page 409)

AT-S63 Management Software Web Browser Interface User’s Guide
Section VI: Port Security 409
5. To see the port settings, click the port and click Settings. You can
select more than one port at a time.
Note
To view the settings of multiple ports, you must select ports that
have the same port role (authenticator or supplicant).
For authenticator port(s), the Authenticator Port Parameters page is
displayed, as shown in Figure 168.
Figure 168. Authenticator Port Parameters Page
The Authenticator Port Parameters page displays a table that contains
the following columns of information:
Port
The port number.
PortCtrl
The port control setting. The possible settings are:
Force-authorized - 802.1x port-based authentication is disabled.
Force-unauthorized - The port is in an unauthorized state, ignoring
attempts by the client to authenticate.
Auto - 802.1x port-based authentication is enabled.
QuietP
The number of seconds the port remains in a quiet state following a
failed authentication exchange with the client.
TxP
The number of seconds that the switch waits for a response to an EAP
Request packet/identity packet from the client before retransmitting the
request.
ReAuthP
The frequency of the periodic reauthentication of the client.