Allied Telesis AT-S63 - Manual (Page 275)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 275
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
ˆ “Creating a Target Address Table Entry” on page 268
ˆ “Deleting a Target Address Table Entry” on page 271
ˆ “Modifying Target Address Table Entry” on page 272
For reference information about the SNMPv3 Target Parameters Table,
see Chapter 22, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a Target
Parameters Table
Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 108.
Figure 108. SNMPv3 Target Parameters Table Tab (Configuration)