Allied Telesis AT-S63 - Manual (Page 232)

Chapter 18: SNMPv3
232 Section III: SNMPv3
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to first enable SNMP access
on the switch. Then you configure the SNMPv3 tables. See the following
procedures:
ˆ “Enabling or Disabling SNMP Management” on page 233
ˆ “Configuring the SNMPv3 User Table” on page 236
ˆ “Configuring the SNMPv3 View Table” on page 244
ˆ “Configuring the SNMPv3 Access Table” on page 250
ˆ “Configuring the SNMPv3 SecurityToGroup Table” on page 257
ˆ “Configuring the SNMPv3 Notify Table” on page 263
ˆ “Configuring the SNMPv3 Target Address Table” on page 268
ˆ “Configuring the SNMPv3 Target Parameters Table” on page 275
ˆ “Configuring the SNMPv3 Community Table” on page 282
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesyn does not recommend this configuration.